 |
 |
 |
 |
||
| Home | Mining & Industrial | LCR & Water Proofing | SINMAST | Construction | Flooring | Zoopoxy & Sculpting | Photo Gallery |
|
Injection Resin Urethane Foams Crack Paste Chemical Anchoring Joint Sealants Pick-Proof Liquid Concrete Repair How-To High Modulus Binders Low Modulus Binders Bonding Agents Patching Gel Grouts & Mortar |
Do It Yourself with LCR
Fix Cracks in Poured Concrete the Easy Way
 |
Step 1 Clean the crack and wall with a wire brush. Angle the brush into the crack to remove dirt or loose concrete. |
 |
Step 2 Dry damp spots on the wall with a heat gun or hair dryer. It must remain dry for at least 15 minutes. |
 |
Step 3 Using a small amount of sealer paste, secure ports over the crack at 12-in. intervals |
 |
Step 4 After the ports set, spread sealer paste 1/8 in. thick over the crack. Around ports, apply the paste slightly thicker. |
 |
Step 5 Remove the shipping tape. Then jerk the plunger up in quick motion to separate the mixing wheel from the foil barrier. |
 |
Step 6 Inject the liquid epoxy until it runs out of the port above. Then cap off the port you are injecting and move up the wall. |
|
POLYGEM, Inc.
P.O. Box 609 West Chicago, IL 60186 www.polygem.com |
polygem@ntsource.com
Ph: (630) 231-5600 Ph: (888) 446-3987 Fx: (630) 231-5604 |