LIQUID CONCRETE REPAIR PASTE

3. PRODUCT DESCRIPTION
LCR EPOXY REPAIR PASTE is a unique new water clean-up epoxy repair paste designed to provide high-strength bonding for all types of repair projects. LCR is ideal for homeowners, contractors, remodelers, maintenance personnel and D.I.Y users.

Advantages / Features

EASY TO MIX
HIGH STRENGTH
SANDABLE
PAINTABLE
NO SHRINKAGE
SAFE TO USE
PERMANENT REPAIRS

Uses
Bonds Concrete, Wood, Fiberglass, and Metal

Concrete Cracks
Driveways
Sidewalks
Patios
Floors
Pools
Foundations
Wood Rot Repair
Laminating
Shaping
Gluing
Auto Body
Thread-Lock
Pipe Repair
Metal Joining
Boats
Hot Tubs
Modeling
Sculpting
Anchoring
Tile Adhesive
Household Repairs
Hobbies & Crafts

4. APPLICATION INSTRUCTIONS

Surface. should be clean and dry.
Mix equal amounts of Part A & Part B.
Mix only small amounts that can be used in 20 minutes.
Allow epoxy to fully cure for 24 hours

BONDING:

Apply mixed epoxy to both surfaces to be joined.
Press together firmly and clamp or brace.
Allow 24 hour cure before sanding or painting.

Anchoring:

Drill hole 1/8” larger than anchor.
Fill hole half way with mixed epoxy and insert anchor with twisting motion. Epoxy should be level with surface when anchor is fully inserted.
Do not disturb anchor for 24 hours.

Patching:

Apply mixed epoxy evenly over surface to be repaired.
Water may be used on trowel or putty knife to obtain smooth surface

Grouting:

Add sand, gravel, sawdust or metal filings to mixed ppoxy to produce trowelable mortar for grouting.
Allow 24 hours before sanding or painting.

Consult Polygem for additional technical instructions

Packaging
Part A and Part B: Net weight 17 ounces

Cautions

KEEP OUT OF REACH OF CHILDREN!
ALWAYS WEAR RUBBER GLOVES AND EYE PROTECTION WHEN HANDLING THIS PRODUCT.

5.TECHNICAL DATA

Performance Properties

Test Test Method Results

Tensile Strength ASTM D-638 5,500 psi

Compressive Strength ASTM D-695 14,500 psi

Impact Strength ASTM D-256 .22 ft. lbs./in. notch

Heat Deflection Temperature ASTM D-648 165° F

Working Time @ 77° F 20 minutes

Cure Time @77° F 24 hours

Polygem, Inc. warrants its products to be free of manufacturing defects and that, at the time and place of shipment, our material will meet current physical properties when applied within Polygem’s directions and tested in accordance with ASTM and Polygem standards. Polygem, Inc’s liability is limited to replacement of material found defective. As Polygem, Inc. has no control over the use to which others may put its products, it is recommended that the product be tested to determine if suitable for a specific application and/or our information is valid in a particular circumstance. Responsibility remains with the architect or engineer, contractor and owner for the design, application and proper installation of each product. Nothing contained herein shall be construed to be a recommendation to use or as a license to operate under or to infringe any existing patents.

Data sheets are subject to change without notice, for latest revision check our website at www.polygem.com