POLYBAC #1002FS - POLYGEM, Inc.

3. PRODUCT DESCRIPTION
POLYBAC #1002FS is a 100% solids, moisture insensitive, epoxy paste used primarily for sealing cracks prior to injection with POLYJECT #1001. This fast curing paste enables the user to inject within 1/2 hour after applying the paste to the concrete surface. POLYBAC #1002 FS can be applied vertically horizontally or overhead.

Advantages / Features

MEETS CRITERIA FOR ASTM C881, TYPE I, GRADE 3, CLASS A,B & C
SEALS CRACKS PORIOR TO INJECTION WITHIN 30 MINUTES
MOISTURE INSENSITIVE
PINS LOOSE OR BROKEN MASONRY
FILLS VOIDS AND GAPS
EASY TO FEATHEREDGE
COST EFFECTIVE

4. APPLICATION INSTRUCTIONS

Mix I part A (Resin) to I part B (Hardener) by volume until uniform gray color. Make sure there are no color streaks after mixing.
Maintain unmixed material temperature above 50° F for best results.
See Recommended Concrete Crack Repair for further information.

Consult Polygem for additional technical instructions

Packaging
22 oz. Cartridge, 2 gallon, 10 gallon, 100 gallon

Cautions

Removal of crack paste by means of burning may produce toxic fumes.
Wear protective clothing and breathing apparatus when removing #1002 FS with heat.

5.TECHNICAL DATA

Performance Properties

Test Test Method Results

Compressive Strength ASTM D-695 7,000 psi (min)

Tensile Strength ASTM D-638 3,000 psi (min)

Tensile Elongation D-638 3% minimum

Slant Shear Strength ASTM C-882 100% Concrete failure (stronger than concrete)

Shore D Hardness ASTM D-2240 85-90

Pot Life @ 75° F (1 Quart) 5-7 minutes

Cure Time @ 75° F 25 minutes

Mix Ratio 1:1 by volume

Coverage 20 sq. ft./ 2 gallon kit

Polygem, Inc. warrants its products to be free of manufacturing defects and that, at the time and place of shipment, our material will meet current physical properties when applied within Polygem’s directions and tested in accordance with ASTM and Polygem standards. Polygem, Inc’s liability is limited to replacement of material found defective. As Polygem, Inc. has no control over the use to which others may put its products, it is recommended that the product be tested to determine if suitable for a specific application and/or our information is valid in a particular circumstance. Responsibility remains with the architect or engineer, contractor and owner for the design, application and proper installation of each product. Nothing contained herein shall be construed to be a recommendation to use or as a license to operate under or to infringe any existing patents.

Data sheets are subject to change without notice, for latest revision check our website at www.polygem.com