POLYBAC #1004FS - POLYGEM, Inc.

3. PRODUCT DESCRIPTION
POLYBAC #1004FS is the original low odor fast setting crack sealer. This two component, 100% solids, epoxy paste is moisture insensitive epoxy paste can be applied vertically, horizontialty or overhead. POLYBAC #1004FS is primarily used to seal cracks prior to injecting cracks with POLYJECT #1001, or to adhere surface mounted injection ports to the concrete surface. POLYBAC #1004 FS can be used indoors without affecting workers or residents with offensive odors.

Advantages / Features

MEETS CRITERIA FOR ASTM C-881, TYPE I, GRADE 3, CLASS B & C
LOW ODOR - NO TOXIC FUMES
USED INDOORS WITHOUT EVACUATING RESIDENTS
MOISTURE INSENSITIVE - CAN BE APPLIED TO WET OR DRY SURFACES
RAPID SET FOR FAST JOB COMPLETION
EASILY MIXED AND FEATHEREDGED
PINS LOOSE OR BROKEN MASONRY
COST EFFECTIVE

4. APPLICATION INSTRUCTIONS

Mix 1 part A (Resin) to 1 part B (Hardener) by volume until uniform gray color. Make sure there are no color streaks after mixing.
Maintain unmixed material temperature above 50° F for best results.
See Recommended Concrete Crack Repair for further information.

Consult Polygem for additional technical instructions

Packaging
2 gallon, 4 gallon, 10 gallon, 100 gallon kits

5.TECHNICAL DATA

Performance Properties

Test Test Method Results

Compressive Strength ASTM D-695 7,000 psi (min)

Tensile Strength ASTM D-638 3,000 psi (min)

Tensile Elongation D-638 3% minimum

Slant Shear Strength ASTM C-882 100% Concrete failure (stronger than concrete)

Shore D Hardness ASTM D-2240 85-90

Pot Life @ 75° F (1 Quart) 8-12 minutes

Cure Time @ 75° F 30-40 minutes*

Cure Time (under water) @ 75° F 2-3 hours

Mix Ratio 1:1 by volume

Coverage 20 sq. ft./ 2 gallon kit

* POLYBAC #1004 FS will take longer to cure if material andlor concrete are below 75° F.
Apply external heat to accelerate cure time.

Polygem, Inc. warrants its products to be free of manufacturing defects and that, at the time and place of shipment, our material will meet current physical properties when applied within Polygem’s directions and tested in accordance with ASTM and Polygem standards. Polygem, Inc’s liability is limited to replacement of material found defective. As Polygem, Inc. has no control over the use to which others may put its products, it is recommended that the product be tested to determine if suitable for a specific application and/or our information is valid in a particular circumstance. Responsibility remains with the architect or engineer, contractor and owner for the design, application and proper installation of each product. Nothing contained herein shall be construed to be a recommendation to use or as a license to operate under or to infringe any existing patents.

Data sheets are subject to change without notice, for latest revision check our website at www.polygem.com