POLYBAC® #1101 - POLYGEM, Inc.

3. PRODUCT DESCRIPTION
Polybac #1101 is a 100% solids, two component, structural epoxy specifically formulated as a primer to bond epoxy mortar to concrete. The low viscosity, moisture insensitive epoxy can be scrubbed onto sound concrete prior to the placement of the epoxy mortar (POLYBAC #1111).

This chemical and wear resistant binder can be used as a resurfacer or patching compound for the repair of floors. POLYBAC #1101 can also be utilized as a clear, high-build non-gloss coating. Aggregate may be added to produce a mortar, which provides excellent wear resistance as a floor topping or patching mode or spalled concrete.

Advantages / Features

MEETS CRITERIA FOR ASTM C 881, TYPE I, II, IV & V GRADE 1, CLASS B & C
USE AS A BINDER OR COATING
EASLY MIXED
NO SHRINKAGE
EXCELLENT CHEMICAL AND WEAR RESISTANCE
PROVIDES GOOD WATERPROOF PROPERITIES
V.O.C. COMPLIANT
DOT APPROVALS

4. APPLICATION INSTRUCTIONS

Surface should be prepared by using conventional cleaning methods such as shot blasting, acid etching, disc grinding, sandblasting or power washing. The surface to be covered should be free of loose materials, paints, sealants or oils.
Blend 2 parts A (Resin) to 1 part B (Hardener) by volume. Mix with low speed drill until uniform in color. Maintain ingredients above 50° F.
Apply with brush, roller or by spraying. If non-skid coating is desired, broadcast silica sand onto POLYBAC #1101.
For best results, apply epoxy mortar (POLYBAC #1111) within 30 minutes after applying POLYBAC #1101.
Aggregate may be added to achieve epoxy mortar.

Consult Polygem for additional technical instructions

Packaging
16.5 oz cartridge, 1, 5 and 15 gallon kits

5.TECHNICAL DATA

Performance Properties

Test Test Method Results

Compressive Strength ASTM D-695 11,480 psi (min)

Tensile Strength ASTM D-638 8,315 psi (min)

Tensile Elongation D-638 8.9% minimum

Flexural Strength ASTM C-580 4,500 psi (min)

Slant Shear Strength ASTM C-882 2 days 1200

Slant Shear Strength ASTM C-882 14 days 1520

Linear Coefficient of Shrinkage <0.001

Water Absorption, 24 hours 0.1989%

Shore D Hardness ASTM D-2240 90-85

Pot Life @ 75° F (1/2 gallon) 35 minutes

Cure Time @ 75° F 24 hours

Viscosity @ 75° F (mixed) 150 cps

Color Light Amber

Polygem, Inc. warrants its products to be free of manufacturing defects and that, at the time and place of shipment, our material will meet current physical properties when applied within Polygem’s directions and tested in accordance with ASTM and Polygem standards. Polygem, Inc’s liability is limited to replacement of material found defective. As Polygem, Inc. has no control over the use to which others may put its products, it is recommended that the product be tested to determine if suitable for a specific application and/or our information is valid in a particular circumstance. Responsibility remains with the architect or engineer, contractor and owner for the design, application and proper installation of each product. Nothing contained herein shall be construed to be a recommendation to use or as a license to operate under or to infringe any existing patents.

Data sheets are subject to change without notice, for latest revision check our website at www.polygem.com