POLYBAC #580 FS - POLYGEM, Inc.

3. PRODUCT DESCRIPTION
POLYBAC #580FS is a two component, 100% solids, fast setting, epoxy adhesive, formulated as a "fluffy" paste that is easily mixed and applied.

POLYBAC #580FS is an excellent bonding material for ceramic tile, brick, glass, metal, wood, concrete masonry tile and many plastic surfaces.

POLYBAC #580FS can be applied with temperatures being as low as 40°F and will cure very fast if ambient temperature is above 85°F. Mix only enough that can be used in 5 minutes.

4. APPLICATION INSTRUCTIONS

Prepare surf ace to be bonded by sandblasting or scarifying to eliminate all surface scale, rust and unclean matter. Wipe with a clean cloth, soaked with POLYBAC #20 Solvent. Do not apply adhesive onto substrate that is below 50°F without warming the surface first.
Mix 1 part B (Hardener) to 1 part A (Resin) on a separate board until uniform in color. Do not exceed mixing over 1 minute.
Apply mixed components to surface of tile and surface to be bonded. Press tile onto substrate to evacuate air.
Do not move tile after 60 minutes or after initial cure.

Consult Polygem for additional technical instructions

Packaging
2 gallon and 2 quart kits

5.TECHNICAL DATA

Performance Properties

Test Test Method Results

Tensile Strength ASTM D-638 2,800 psi

Compressive Strength ASTM D-695 13,500 psi

Consistency Fluffy paste

Color Part A: White
Part B: Black

Mixed Color Gray

Cure @ 77° F 50% strength in 15 minutes
100% strength in 1 hour

Pot Life @ 77° F 5-10 minutes

Ratio 1:1 by volume

Weight per Kit (net) 21 lbs.

Coverage 25 sq. ft. at ¼” thick

Polygem, Inc. warrants its products to be free of manufacturing defects and that, at the time and place of shipment, our material will meet current physical properties when applied within Polygem’s directions and tested in accordance with ASTM and Polygem standards. Polygem, Inc’s liability is limited to replacement of material found defective. As Polygem, Inc. has no control over the use to which others may put its products, it is recommended that the product be tested to determine if suitable for a specific application and/or our information is valid in a particular circumstance. Responsibility remains with the architect or engineer, contractor and owner for the design, application and proper installation of each product. Nothing contained herein shall be construed to be a recommendation to use or as a license to operate under or to infringe any existing patents.

Data sheets are subject to change without notice, for latest revision check our website at www.polygem.com