#1257 Epoxy - Anchoring Adhesive - 22 oz. Dual Cartridge

Epoxy Chemical Anchoring Adhesive - 22 oz. Dual Cartridge
$22.50
SKU: 1257 22 oz.
Weight: 1 lb
Dimensions: 9 in × 5 in × 5 in
Product Description: 

 #1257 is a 100% solids non-sag gel viscosity epoxy specially formulated for use as general adhesive to provide the ultimate in adhesion to a variety of substrates.  #1257 will bond to concrete, wood, fiberglass and metal surfaces.  #1257 is moisture insensitive and resistant to most chemicals and solvents. #1257 is also excellent as a  epoxy mortar grout for patching or filling large cavity anchoring holes. (Dual Dispensing Gun Required)

Advantages

  • No VOC's or solvants
  • Easy mixing
  • User-friendly

Uses

  • Dowel bar or threaded rod anchoring
  • Hollow block sleeve anchoring
  • Verticle or overhead application
  • Crack repair
  • Epoxy mortars or grouts
Application Instructions: 

 #1257 can be applied by dual-cartridge or bulk applicators

  1. Clean anchor hole by wire brushing the sides of the hole and vacuuming or blowing loose material from the hole
  2. Follow dispensing instructions for the cartridge or bulk dispensing machine
  3. Start filling the hole from the back towards the surface of the hole
  4. Dispense enough material that there is a small amount of overflow when anchor is fully inserted 

(Rule of thumb is anchor hole is to be a minimum of 9x’s deep as the anchor diameter)

Packaging: 

22 oz. Dual Cartridges, 2 Gallon, 10 Gallon and 100 Gallon Kits.

Technical Data: 

**See Data Sheet

Product Category: 


Polygem, Inc. warrants its products to be free of manufacturing defects and that, at the time and place of shipment, our material will meet current physical properties when applied within Polygem’s directions and tested in accordance with ASTM and Polygem standards. Polygem, Inc’s liability is limited to replacement of material found defective. As Polygem, Inc. has no control over the use to which others may put its products, it is recommended that the product be tested to determine if suitable for a specific application and/or our information is valid in a particular circumstance. Responsibility remains with the architect or engineer, contractor and owner for the design, application and proper installation of each product. Nothing contained herein shall be construed to be a recommendation to use or as a license to operate under or to infringe any existing patents.

Data sheets are subject to change without notice.