519 with Large Beads - High Temperature - Wearing Compound

High Temperature Large White Ceramic Bead Wearing Compound
SKU: 519WBLG
Weight: 28 lb
Dimensions: 14 in × 8.5 in × 7 in
Product Description: 

519-WB-LG (with Large Beads) is an epoxy paste blended with abrasion resistant large ceramic beads that was specially formulated to provide protection in areas subjected to elevated temperature conditions.  High temperatures will contribute to premature failure of many polymers, but the 519-WB-LG will provide a durable barrier of protection up to 450 degrees Fahrenheit.  519-WB-LG is an easy to mix 1 to 1 by volume ratio.  519-WB-LG is waterproof and resistant to most chemicals and solvents.  POLYBAC #519-WB-LG is a thick non-sag paste compound that will allow for vertical and overhead patching. 

Advantages

  • Heat Resistant Formulation
  • Extremely durable ceramic matrix.
  • Chemical Resistant
  • No VOC’s or Solvents
  • Low Odor Formula
  • Bonds to most dry surfaces

Uses

For the patching and repair of worn metal or concrete surfaces that are exposed to abrasive environments.  

  • Ball Mills
  • Heat Exchangers and Tube Sheets
  • Cyclones
  • Hopper and Chutes
  • Pump Casings
  • Wear Plates
  • Dust Collection Systems
  • Chipper and Grain Bins
  • Pneumatic Conveyors
  • Pipe Elbows
  • Augers, Fan and Impeller Blades
Application Instructions: 
  1. Clean surface by sandblasting or grinding to provide rough white-metal profile.
  2. Thoroughly mix equal amounts by volume of Part A Resin with Part B Hardener until streak free.  Mix only enough that can be applied in 35 minutes. 
  3. Spread mixed epoxy with trowel or putty knife and worked well into the surface. 
  4. Epoxy may be smoothed with a trowel dipped in a solvent.
Packaging: 

519-WB-LB is available in 2 kit sizes:  2 Quart (7lbs)  Kits and 2 (30 lbs) Gallon Kits.

Product Tags: 


Polygem, Inc. warrants its products to be free of manufacturing defects and that, at the time and place of shipment, our material will meet current physical properties when applied within Polygem’s directions and tested in accordance with ASTM and Polygem standards. Polygem, Inc’s liability is limited to replacement of material found defective. As Polygem, Inc. has no control over the use to which others may put its products, it is recommended that the product be tested to determine if suitable for a specific application and/or our information is valid in a particular circumstance. Responsibility remains with the architect or engineer, contractor and owner for the design, application and proper installation of each product. Nothing contained herein shall be construed to be a recommendation to use or as a license to operate under or to infringe any existing patents.

Data sheets are subject to change without notice.