580FS Tile Adhesive - Fast-Set

Fast-Set Tile Adhesive
SKU: 580FS-2GA
Weight: 28 lb
Dimensions: 14 in × 8.5 in × 7 in
Product Description: 

580FS is a specially formulated epoxy paste to provide a fast setting patching compound for immediate protection of surfaces subject to wear and abrasion. 580FS is an easy to mix 1 to 1 by volume ratio and will cure in as little as 15 minutes. #580FS is ideal for emergency repairs and will minimize down-time of critical equipment and process lines. 580FS is waterproof and resistant to most chemicals and solvents. 580FS is a thick non-sag paste compound that will allow for vertical and overhead patching.

Advantages                             

  • Fast Setting in as little as 15 minutes          
  •  No VOC’s or Solvents
  •  Low Odor Formula
  •  Bonds to most dry surfaces

Uses

Typical application and uses are:

  • Setting Ceramic Tiles
  • Vibrating Screens & Beams
  • Cyclones
  • Hopper and Chutes
  • Pump casings
  • Wear Plates
  • Brick Corners and transitions Areas
  • Dust Collection Systems
  • Chipper and Grain Bins
  • Pneumatic Conveyors
  • Heat Exchangers and Tube Sheets
  • Augers, Fan and Impeller Blades
Application Instructions: 
  1. Clean surface by sandblasting or grinding to provide a white-metal profile.
  2. Thoroughly mix equal amounts by volume of 1 part of Part-A Resin with 1 part of Part-B Hardener by volume until streak free.  
  3. Spread mixed epoxy with trowel or putty knife and work well into the surface.
  4. Epoxy may be smoothed with trowel dipped in solvent.
Packaging: 

2 Gallon Kits

Product Documents: 
Product Category: 


Polygem, Inc. warrants its products to be free of manufacturing defects and that, at the time and place of shipment, our material will meet current physical properties when applied within Polygem’s directions and tested in accordance with ASTM and Polygem standards. Polygem, Inc’s liability is limited to replacement of material found defective. As Polygem, Inc. has no control over the use to which others may put its products, it is recommended that the product be tested to determine if suitable for a specific application and/or our information is valid in a particular circumstance. Responsibility remains with the architect or engineer, contractor and owner for the design, application and proper installation of each product. Nothing contained herein shall be construed to be a recommendation to use or as a license to operate under or to infringe any existing patents.

Data sheets are subject to change without notice.