EZ Karve- Lightweight Sculping Epoxy Putty

EZ Karve Lightweight Sculpting Epoxy Putty
SKU: EZKarve
Weight: 7 lb
Dimensions: 9 in × 5 in × 5 in
Product Description: 

E-Z Karve is a 100% solids light-weight epoxy system specially formulated to a workable ‘clay like’ consistency for sculpturing and modeling projects. E-Z Karve will cure into an extremely strong and durable plastic that is easily sanded or shaped. E-Z Karve can be tinted or painted and will even accept stains. E-Z Karve bonds well to most surfaces including fiberglass, foams, metal, wood and concrete. E-Z Karve is low odor and solvent free so it won’t melt or dissolve foam surfaces.  E-Z KARVE was formulated with a proprietary internal reinforcing that yields a very strong yet light-weight polymer.

E-Z Karve is used as a free form sculpturing medium or applied as a textured veneer over other surfaces. E-Z Karve is ideal for small or intricate detail work where strength and durability are desired. E-Z Karve can also be used as a patching compound to repair broken or damaged exhibits.  EZ Karve can be carved with carving tools when fully cured and is easy to sand.

Application Instructions: 

Wear protective gloves when handling EZ Karve.  Mix equal parts of Part A and Part B by hand for 2-3 minutes until streak free.  Keep a wet paper towel or rag nearby so you can wipe and moisten your gloves for easier handling of EZ Karve.  Water can be applied to the EZ Karve surface to aid in smoothing out the surface as your work with it.


2 Pint, 2 Quart, 2 Gallon &  10 Gal. Kits

Technical Data: 



Product Category: 
Product Tags: 

Polygem, Inc. warrants its products to be free of manufacturing defects and that, at the time and place of shipment, our material will meet current physical properties when applied within Polygem’s directions and tested in accordance with ASTM and Polygem standards. Polygem, Inc’s liability is limited to replacement of material found defective. As Polygem, Inc. has no control over the use to which others may put its products, it is recommended that the product be tested to determine if suitable for a specific application and/or our information is valid in a particular circumstance. Responsibility remains with the architect or engineer, contractor and owner for the design, application and proper installation of each product. Nothing contained herein shall be construed to be a recommendation to use or as a license to operate under or to infringe any existing patents.

Data sheets are subject to change without notice.