LCR - 10 oz Cartridge - Epoxy Injection Resin - "Free Shipping"!

Single Caulk-style cartridge (Must use with Crack Paste)
$29.98
SKU: LCR-CARTRIDGE
Weight: 0.0001 g
Dimensions: 15 in × 14 in × 9 in
Product Description: 

"Free Shipping!!"

LCR  MV  is a 100% solids, two-component, moisture insensitive epoxy designed to permanently restore structure and design strength to cracked concrete structures. 

Unique wetting properties allow maximum penetration of LCR  MV  into cracks above .005”. 

The LCR  MV  can be used on wet or dry surfaces. 

Fits most standard caulk dispensing guns. (Use with LCR Crack Sealer Paste) 

Outstanding Features:

  • Meets ASTM C881, Types I, II, IV & V,
  • Grades 1 & 2,           
  • Class B & C..
  • No VOC’s or Solvents
  • 100% solids
  • Chemical and Solvent Resistant
  • Restores Structural Strength
  • Excellent Adhesion to concrete, wood, fiberglass and metal surfaces.

Uses:

  • Basement foundation crack repair.*
  • Industrial warehouse and residential floors
  • Patios and sidewalks
  • Balcony, pool and parking decks
  • Reservoir, tank and pool leak repair.*

*For injecting LCR Epoxy Cartridge into foundation cracks, the LCR Epoxy Repair Paste and LCR Injection ports are required or you can simply purchase the LCR Repair Kit which has all the componenets needed to repair an average 8' tall crack, 1/6" wide. **See LCR  MV  recommended concrete crack repair data sheet for additional instructions.

Application Instructions: 
  1. Mix entire contents of cartridge according to mixing instructions.
  2. Place cartridge into standard caulking gun.
  3. Dispense mixed material and use up entire contents within 15 minutes.
  4. Do not exceed a “firm handshake” pressure when dispensing with caulk gun.
  5. Clean up any uncured epoxy with solvent.
Packaging: 

Single 10 Ounce Cartridges - 20 per case



Polygem, Inc. warrants its products to be free of manufacturing defects and that, at the time and place of shipment, our material will meet current physical properties when applied within Polygem’s directions and tested in accordance with ASTM and Polygem standards. Polygem, Inc’s liability is limited to replacement of material found defective. As Polygem, Inc. has no control over the use to which others may put its products, it is recommended that the product be tested to determine if suitable for a specific application and/or our information is valid in a particular circumstance. Responsibility remains with the architect or engineer, contractor and owner for the design, application and proper installation of each product. Nothing contained herein shall be construed to be a recommendation to use or as a license to operate under or to infringe any existing patents.

Data sheets are subject to change without notice.