Sinmast #4 Rapid

Medium Viscosity Fast-Set Epoxy Resin
$59.89
SKU: SinmastRapid
Weight: 10 lb
Dimensions: 14 in × 8 in × 7 in
Product Description: 

SINMAST #4 Rapid is a fast-setting, fast-curing industrial epoxy formulated for concrete patching and repair. Mix SINMAST #4 Rapid with sand or aggregates to make epoxy grouts. SINMAST #4 Rapid is also an excellent choice for fiberglass lay up and laminating applications.  SINMAST #4 Rapid does not contain solvents or toxic styrenes.

Advantages:

  •  High-Strength
  •  Stronger than cementitious grouts
  •  Easy mixing pre-measured kits
  •  No Shrinkage
  •  Bonds well to most dry surfaces

Uses:

  • Crack and Joint Repair
  • Epoxy Grouts
  • Machine Bases
  • Patching and Resurfacing
  • Anchoring 
  • Joint Nosings
  • Precision Grouting
  • Rail and Sole Plates
Application Instructions: 
  1. Clean surface by sand blasting or grinding to provide clean and open surface.
  2. Thoroughly mix measured amounts of 1 part of Part-A Resin with 1 part of Part-B Hardener by volume until streak free. 
  • Scrape side and bottom of pail frequently during mixing to insure a good mix. Mix only enough that can be applied in 20 minutes. 

                                                                                                                                                                                                                     

Packaging: 

One Gallon and 5 Gallon Kits

Technical Data: 

 

 



Polygem, Inc. warrants its products to be free of manufacturing defects and that, at the time and place of shipment, our material will meet current physical properties when applied within Polygem’s directions and tested in accordance with ASTM and Polygem standards. Polygem, Inc’s liability is limited to replacement of material found defective. As Polygem, Inc. has no control over the use to which others may put its products, it is recommended that the product be tested to determine if suitable for a specific application and/or our information is valid in a particular circumstance. Responsibility remains with the architect or engineer, contractor and owner for the design, application and proper installation of each product. Nothing contained herein shall be construed to be a recommendation to use or as a license to operate under or to infringe any existing patents.

Data sheets are subject to change without notice.