Sinmast 501 - Flexible Coating

Flexible Coating/Membrane/Crack & Joint Filler
$67.89
SKU: Sinmast501
Weight: 10 lb
Dimensions: 14 in × 8 in × 7 in
Product Description: 

Sinmast 501 is a 100% solids, flexibilized two-part epoxy joint filler specifically formulated to meet the punishing demands of today’s industrial floors.  Sinmast 501 is used to fill and repair joints and cracks subjected to hard wheeled traffic and will provide for a flexible and durable surface.  It is flexible, resilient and will help protect floor cracks, saw-cut and control joints from cracking or spalling of the joint edges. 

Sinmast 501 can also be mixed with sand and applied as a coating for a resilient non-skid surface. 

 Features: 

  • Easy mixing & pouring
  • Self leveling or gel formulas
  • Bonds to damp surfaces 
  • Excellent chemical and solvent resistance
  • Non-shrinking

Uses:

  • Joint and crack sealing and repair
  • Flexible Membrane Coating
  • Swimming Pools and Waterslides
  • Waterproofing Membrane
Application Instructions: 
  1. Clean surface by sand blasting or grinding to provide clean and open surface.
  2. Thoroughly mix measured amounts of 1 part of Part-A Resin with 1 part of Part-B Hardener by volume until streak free. 
  3. Pour Sinmast #501 into joint flush to surface.
  • Scrape side and bottom of pail frequently during mixing to insure a good mix.
  • Mix only enough that can be applied in 45 minutes. 
  • Excess material can be removed with a razor knife after 3-4 hours of cure.                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                      

For Membrane Coating:

  1. Spread mixed epoxy with a notched squeegee and back roll with a 3/8” nap roller to desired coating mil thickness. 
  • Broadcast silica sand into wet coating for additional abrasion resistance or aluminum oxide into wet coating for skid resistance if required.
Packaging: 

One Gallon and 5 Gallon Kits



Polygem, Inc. warrants its products to be free of manufacturing defects and that, at the time and place of shipment, our material will meet current physical properties when applied within Polygem’s directions and tested in accordance with ASTM and Polygem standards. Polygem, Inc’s liability is limited to replacement of material found defective. As Polygem, Inc. has no control over the use to which others may put its products, it is recommended that the product be tested to determine if suitable for a specific application and/or our information is valid in a particular circumstance. Responsibility remains with the architect or engineer, contractor and owner for the design, application and proper installation of each product. Nothing contained herein shall be construed to be a recommendation to use or as a license to operate under or to infringe any existing patents.

Data sheets are subject to change without notice.