1001MV - Medium Viscosity- Injection Epoxy

High Strength Medium-Viscosity Injection Epoxy Resin
$22.45
SKU: 1001MV
Weight: 2 lb
Dimensions: 9 in × 5 in × 5 in
Product Description: 

#1001MV is a 100% solids, two-component, moisture insensitive epoxy designed to penetrate hairline cracks in  concrete structures.  Unique wetting properties allow maximum penetration of #1001 MV into cracks as small as .005”. Static Mixer and Locking Nut NOT included. (Dual Dispensing Gun Required)

Outstanding Features

  • Meets ASTM C881, Types I, II, IV & V Grade 2
  • Class B & C..
  • No VOC’s or Solvents
  • 100% solids
  • Chemical and Solvent Resistant
  • Excellent Adhesion to concrete, wood, fiberglass and metal surfaces.

Uses

For permanently repair and seal cracks in concrete such as:

  • Basement foundation crack repair.*
  • Industrial warehouse and residential floors
  • Patios and sidewalks
  • Balcony, pool and parking decks
  • Reservoir, tank and pool leak repair.*

*See #1001 MV recommended concrete crack repair data sheet for additional instructions.

Application Instructions: 
  1. Mix 2 parts A (Resin) to 1 part B Hardener) by volume.  Avoid mixing more than ½ gallon at a time.
  2. Stir with a mixing stick or slow speed drill with a mixing paddle for 1-2 minutes until streak free and uniform in color.  Scrape sides and bottom of mixing pail during mixing and do not over mix more than 3 minutes.  Avoid whipping air into mixture.
  3. Dispense or apply mixed material and use within 15 minutes.
  4. Follow cartridge dispensing instructions if using single or dual cartridge packaging.
  5. Clean up any uncured epoxy with solvent.
Packaging: 

16.5 oz. Dual Cartridges, 1.5 Gallon, 3 Gallon, 15 Gallon, 75 Gallon and 150 Gallon Kits.

Product Category: 


Polygem, Inc. warrants its products to be free of manufacturing defects and that, at the time and place of shipment, our material will meet current physical properties when applied within Polygem’s directions and tested in accordance with ASTM and Polygem standards. Polygem, Inc’s liability is limited to replacement of material found defective. As Polygem, Inc. has no control over the use to which others may put its products, it is recommended that the product be tested to determine if suitable for a specific application and/or our information is valid in a particular circumstance. Responsibility remains with the architect or engineer, contractor and owner for the design, application and proper installation of each product. Nothing contained herein shall be construed to be a recommendation to use or as a license to operate under or to infringe any existing patents.

Data sheets are subject to change without notice.